Table of Contents
Advertisement
I
NSTALLATION
C
I
(I
ABLE
NSTALLATION
F
S
USB
ULL
PEED
10. Configure the StratosS to match the host system's USB parameters.
For Single Cable Applications:
The IBM OEM Full Speed USB English and Metric bar codes are located in the MS2xxx Stratos Series
Configuration Addendum (
POS Compatibility, IBM OEM Full Speed USB.
For Dual Cable Applications:
The IBM OEM Full Speed USB Communication Defaults bar code is located in the MS2xxx Stratos Series
Configuration Addendum (
Configuration Bar Codes, IBM OEM Full Speed USB Communication Defaults and IBM OEM Full Speed USB
Protocols.
F
USB S
E
OR
ERIAL
MULATION
These features can only be used for Dual Cable Applications.
11. Configure the StratosS for USB Serial Emulation Mode or USB Keyboard Emulation Mode by scanning the
appropriate configuration bar codes in the USB section of the MetroSelect Configuration Guide (
under Low Speed USB. Any low speed USB warnings may be disregarded when utilizing these codes for a
Full Speed USB StratosS scanner.
These features can only be used for Dual Cable Applications. The IBM OEM Full Speed USB
Communication Defaults bar code listed in step 10 must be scanned before scanning one of these barcodes or
this feature will not work properly.
20
S
)
NTERFACE
PECIFIC
00-02034x) under Scanner Configuration Bar Codes: Single Cable Protocols for
MLPN
00-02034x) under Scanner Configuration Bar Codes: Dual Cable Scanner
MLPN
M
K
E
ODE OR
EYBOARD
MULATION
M
O
ODE
NLY
00-02407x)
MLPN
Advertisement
Table of Contents
