Software Installation Procedure From The Cd; Attach Monitor & Keyboard; 3.3.2. Bios Setup - Vidicode APRESA Installation Manual

Software installation Software i Software i Software i nstallation nstallation procedure nstallation
3.3.
THE IMAGE CD USED BY THIS INSTALLATION PROCEDURE
CONTAINS THE LINUX 64BIT OPERATING SYSTEM
IF THE SYSTEM USES ONE IF THE SYSTEM USES
IF THE SYSTEM USES IF THE SYSTEM USES
FIX FIX FIX : FIX
If the APRESA base software is already installed without interface cards for whatever reason, run
from the WEB-interface: Tools->System->Install Driver.
3.3.1. 3.3.1.
3.3.1. 3.3.1.
Always attach a monitor & keyboard to follow the progress of the software installation and to:
• Change BIOS settings;
• Give a confirmation to overwrite current hard drive content if the hard drive you want to
use is not empty;
• Type the pass phrase, if the hard drive is to be encrypted during installation and at each
reboot;
3.3.2.

3.3.2. BIOS setup

BIOS setup
3.3.2. 3.3.2. BIOS setup BIOS setup
(Note : Controls used below refer to Phoenix BIOS, other BIOS manufacturers may be different)
Enter the BIOS configuration menu by pushing
take up to 1 minute.
GENERAL SETTINGS GENERAL SETTINGS
Select: " GENERAL SETTINGS GENERAL SETTINGS
- SET: DATE & TIME;
- SET: HARD DRIVE Pre-Delay to 6 seconds.
BOOT SETTINGS BOOT SETTINGS
Select : " BOOT SETTINGS BOOT SETTINGS
- SET : boot-sequence to:
When installing the RAID1 or RAIID5 version of APRESA you must set the BIOS When installing the RAID1 or RAIID5 version of APRESA you must set the BIOS When installing the RAID1 or RAIID5 version of APRESA you must set the BIOS- - - - When installing the RAID1 or RAIID5 version of APRESA you must set the BIOS
SAVE & EXIT
Select : " " (enter :
procedure procedure procedure from the CD from the CD from the CD from the CD
PROPRIETARY APRESA APPLICATION SOFTWARE
ONE OR MORE INTERFACE
ONE ONE
PRIOR TO SOFTWARE INSTALLATION
Attach moni Attach monitor & keyboard tor & keyboard
Attach moni Attach moni tor & keyboard tor & keyboard
" :
" :
DVD ,
( RAID is handled by software )
F10 & Y
APRESA INSTALLATION MANUAL VIDICODE ©2012
OR MORE INTERFACE CARDS ALWAYS INSTALL
OR MORE INTERFACE OR MORE INTERFACE
THESE CARDS THESE CARDS THESE CARDS THESE CARDS
DEL repeatedly, directly after power on. This can
IDE0, and if more HD-s
setting for RAID to setting for RAID to setting for RAID to setting for RAID to
NO RAID
)
AND
THE
CARDS ALWAYS INSTALL
CARDS ALWAYS INSTALL CARDS ALWAYS INSTALL
IDE1 and further. .
18