Installing The Optional Smartcard Reader Board; Removing The Optional Finger Print Reader Board - Dell Precision 3510 Owner's Manual

3. To remove the SmartCard reader board:
a. Disconnect the SmartCard reader board cable from the USH board [1, 2].
b. Peel the cable to release from the adhesive.
c. Remove the screws that secure the SmartCard reader board to the computer [3].
d. Lift the SmartCard reader board from the computer [4].

Installing the optional SmartCard reader board

1. Insert the SmartCard reader board into the slot on the computer.
2. Tighten the screws to secure the SmartCard reader board to the computer.
3. Connect the SmartCard reader cable to the connector on the USH board.
4. Install the:
a. dock frame
b. hard drive assembly
c. battery
d. base cover
5. Follow the procedure in

Removing the optional finger print reader board

1. Follow the procedure in
2. Remove the:
a. base cover
b. battery
c. hard drive assembly
d. dock frame
e. WLAN card
f. WWAN card
3. To remove the finger print reader board:
or M.2 SSD or PCIe SSD
After working inside your
Before working inside your
or M.2 SSD or PCIe SSD
computer.
computer.
25