Installation - Kenwood TK-782 Service Manual

TK-782
1. Accessory Connection Cable
(KCT-19 : Option)
The KCT-19 is an accessory connection cable for connect-
ing external equipment. The connector has 15 pins and the
necessary signal lines are selected for use.
1-1. Installing the KCT-19 in the transceiver
1. Remove the upper and lower half of the transceiver case,
and lift the DC cord bushing (
2. Remove the pad as shown in Figure 1 (
3. Insert the KCT-19 cable (
The wire harness band (
4. Replace the DC cord bushing (
5. Connect the KCT-19 to the TX-RX unit (A/2) as shown in
Figure 2 ( ).
%
6. Connect the KCT-19 to the external accessory by inserting
the crimp terminal (
of which are supplied with the KCT-19.
Fig. 1 /
28

INSTALLATION /

) from the chassis.
).
) into the chassis (
! "
) must be inside the chassis.
#
).
$
) into the square plug (
& '
D
E
B
C
%
).
%
), both
C
B
CN4 CN1 B
CN2
CN3
CN6
$
Fig. 2 /
! "
#
$
'
&
E
D
#
"
'
!
A
13
15
Crimp terminal
(E23-0613-05)
Square plug
(E09-1571-05)
1
3
Contact /
&