Kenwood TK-782 Service Manual page 60

Test Mode
! Test Mode Operating Features
This transceiver has a test mode. To enter test mode,
press [B] key and turn power on. Hold [B] key until test
channel No. and test signalling No. appears on LCD. Test
mode can be inhibited by programming. To exit test mode,
switch the power on again. The following functions are avail-
able in test mode.
" Controls ("SFT" appears)
[PTT] Used when making a transmission.
[!] Shift off.
[A] FFSK 1200 bps and 2400 bps.
[B] Shift off.
[ C] Compander function on and off.
[D ] Beat shift on and off.
[CALL] Shift off.
[Channel Up/Down] Shift off.
[Volume Up/Down] Shift off.
" Controls ("SFT" not appears)
[PTT] Used when making a transmission.
[!] Monitor on and off.
[A] Sets to the tuning mode.
[B] Shift on.
[ C] RF power high and low.
[D ] Changes signalling.
[CALL] Changes wide and narrow.
[Channel Up/Down] Changes channel.
[Volume Up/Down] Volume up/down.
Note : If a [A], [B], [ C], [D
mission, the DTMF corresponding to the key that was pressed
is sent.
" LCD indicator
"SCN" Unused.
" " Lights at compander on.
"AUX" Unused.
" " Lights at RF power low.
"MON" Lights at monitor on.
"SVC" Unused.
" " Lights at FFSK 2400 bps.
" LED indicator
Red LED Lights during transmission.
Green LED Lights when there is a carrier.
" Sub LCD indicator
"SFT" Appears at shift on.
ADJUSTMENT /
] key is pressed during trans-
!
"
!
"
!
"
"
"
TK-782
59