Using Hp Pc Hardware Diagnostics (Uefi) (Select Models Only) - HP ProBook 11 G1 Education Edition Maintenance And Service Manual

●
To specify a boot device from the Express Boot menu, select your preference within the allotted time,
and then press enter.
●
To prevent the computer from defaulting to the current MultiBoot setting, press any key before
the allotted time expires. The computer will not start until you select a boot device and press enter.
●
To allow the computer to start according to the current MultiBoot settings, wait for the allotted time to
expire.

Using HP PC Hardware Diagnostics (UEFI) (select models only)

HP PC Hardware Diagnostics is a Unified Extensible Firmware Interface (UEFI) that allows you to run
diagnostic tests to determine if the computer hardware is functioning properly. The tool runs outside
of the operating system to isolate hardware failures from issues that may be caused by the operating system
or other software components.
To start HP PC Hardware Diagnostics UEFI:
1. Turn on or restart the computer, quickly press esc, and then press f2.
After pressing f2, the BIOS searches three places for the HP PC Hardware Diagnostics (UEFI) tools in
the following order:
a. Connected USB drive
NOTE:
HP PC Hardware Diagnostics (UEFI) to a USB device on page
b. Hard drive
c. BIOS
2. Use the keyboard arrow keys to select the type of diagnostic test you want to run, and then follow
the on-screen instructions.
NOTE:
To download the HP PC Hardware Diagnostics (UEFI) tool to a USB drive, see
If you need to stop a diagnostic test while it is running, press esc.
Using HP PC Hardware Diagnostics (UEFI) (select models only)
76.
Downloading
75