Fan/Heat Sink Assembly - HP ProBook 11 G1 Education Edition Maintenance And Service Manual

Fan/heat sink assembly

Description
Fan/heat sink assembly (includes fan cable, 4 captive screws [secured by C-clips], and replacement
thermal material)
Before removing the fan/heat sink assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Bottom cover (see
b. Hard drive (see
c. WWAN module (see
d. Keyboard/top cover (see
e. System board (see
Remove the fan/heat sink assembly:
1. Turn the system board upside down with the front toward you.
2. Disconnect the fan cable (1) from the system board.
3. Loosen the four Phillips captive screws (2) that secure the fan/heat sink assembly to the system board.
NOTE:
assembly and system board components, it may be necessary to move the fan/heat sink assembly from
side to side to detach it.
58 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
Bottom cover on page
Hard drive on page
WWAN module on page
Keyboard/top cover on page
System board on page
Due to the adhesive quality of the thermal material located between the fan/heat sink
24), and then remove the following components:
26)
28)
33)
48)
55)
Spare part number
809857-001