NEC EXPRESS5800/120Ef Service Manual page 45

e. If the restore finishes, the following message will be displayed.
Flash memory has been successfully programmed
PRESS ANY KEY TO RESTART THE SYSTEM
If the system does not restart
TURN THE POWER OFF, THEN ON
f. Press enter, the system is rebooted.
g. After the system re-starts, enter [chk] and check the system information.
If the System is Unable to Make Backup of system Information
When the mother board for exchange does not operate, exchange mother board and
perform the following procedure.
a. After the system is booted from floppy disk, following message appears. Input new and
hit return key.
*************************************************************************************
Welcome to the FRU backup/restore procedure. Select one of the four
options listed below.
1) To backup the FRU data of your system, Type: bk [Enter]
2) To restore the FRU data into your system, Type: res [Enter]
If you want to update the chassis information, Type: res /c [Enter]
3) To update the FRU data into your system, Type: new [Enter]
If you want to update the chassis information, Type: res /c [Enter]
4) To check the FRU data in your system, Type: chk [Enter]
*************************************************************************************
A :¥> new [Enter]
b. Enter the number that corresponds to the changed machine after Product name and
N-CODE were appeared.
===============================================================
0. NEXT
1. Express5800/120Ef_ [N8100-857]
2. Express5800/120Ef_ [N8100-858]
3. Express5800/120Ga_ [N8100-875]
4. NEC_Express5800/120Ef_ [N8100-857F]
5. NEC_Express5800/120Ef_ [N8100-858F]
6. NEC_Express5800/120Ef_ [N8100-857E]
7. NEC_Express5800/120Ef_ [N8110-52E]
Product Name(1-7,0:NEXT): ｎ
39