NEC EXPRESS5800/120Ef Service Manual page 31

On-screen error message
0B1B PCI System Error on
Bus/Device/Function
0B1C PCI Parity Error on
Bus/Device/Function
0B22 Processors are
installed out of order.
0B28 Unsupported
Processor detected on
Processor 1
0B29 Unsupported
Processor detect on
Processor 2
0B50 CPU #1 with error
taken off line
0B51 CPU #2 with error
taken off line
0B5F Forced to use
Processor with error
0B60 DIMM group #1 has
been disabled
0B61 DIMM group #2 has
been disabled
0B62 DIMM group #3 has
been disabled
0B63 DIMM group #4 has
been disabled
8100 Memory Error
detected in DIMM
group #1
8101 Memory Error
detected in DIMM
group #2
8102 Memory Error
detected in DIMM
group #3
8103 Memory Error
detected in DIMM
group #4
8150 NVRAM Cleared By
Jumper
Description Cause
A PCI system error
occurred on the bus,
device, or function.
A PCI parity error
occurred on the bus,
device, or function.
Failure of a processor The abnormalities in a
processor
The processor which is
not supported by the
processor 1 is carried.
The processor which is
not supported by the
processor 2 is carried.
CPU #1 was degraded 1. Fault CPU# 1
due to an error detected
2. Fault Mother Board
for CPU #1.
CPU #2 was degraded 1. Fault CPU# 2
due to an error detected
2. Fault Mother Board
for CPU #1.
A CPU error was
detected.
A memory error was
detected. Memory #1
is degraded.
A memory error was
detected. Memory #2
is degraded.
A memory error was
detected. Memory #3
is degraded.
A memory error was
detected. Memory #4
is degraded.
The memory error was DIMM error
discovered.
NVRAM was cleared The abnormalities in a
by jumper setup. jumper setting
Action
1. CPU Exchange
2. Mother Board Exchange
1. CPU #1 Exchange
2. Mother Board Exchange
1. CPU #2 Exchange
2. Mother Board Exchange
1. CPU Exchange
2. Mother Board Exchange
1. Exchange of Memory #1
2. Mother Board Exchange
1. Exchange of Memory #2
2. Mother Board Exchange
1. Exchange of Memory #3
2. Mother Board Exchange
1. Exchange of Memory #4
2. Mother Board Exchange
Two DIMM is exchanged.
A jumper setup after power
supply OFF is returned to a
default.
25