Table of Contents
Advertisement
g. After reboot from Floppy Disk, following message appears.
************************************************************************************
Welcome to the FRU backup/restore procedure. Select one of the four
options listed below.
1) To backup the FRU data of your system, Type: bk [Enter]
2) To restore the FRU data into your system, Type: res [Enter]
If you want to update the chassis information, Type: res /c [Enter]
3) To update the FRU data into your system, Type: new [Enter]
If you want to update the chassis information, Type: res /c [Enter]
4) To check the FRU data in your system, Type: chk [Enter]
************************************************************************************
h. Input the bk and hit return. Backup will be started. .
The system information for exchange is displayed and the information is written in a
floppy disk.
The setup information on BIOS is not backed up by this operation.
Backup the setup information on BIOS using offline utility including NEC
EXPRESSBUILDER.
If backup of all information is completed, please turn off the power supply
and perform exchange work of a mother board.
Restore the system information
a. Set the backup Floppy Disk of system information in the Floppy Disk drive, and boot the
Floppy Disk Drive.
b. The following message appears after the boot from Floppy disk written backup data.
************************************************************************************
Welcome to the FRU backup/restore procedure. Select one of the four
options listed below.
1) To backup the FRU data of your system, Type: bk [Enter]
2) To restore the FRU data into your system, Type: res [Enter]
If you want to update the chassis information, Type: res /c [Enter]
3) To update the FRU data into your system, Type: new [Enter]
If you want to update the chassis information, Type: res /c [Enter]
4) To check the FRU data in your system, Type: chk [Enter]
************************************************************************************
c. Input the [res] and hit return. Since Write Data is appear, check it and hit y.
d. The restore will be started. It will take about 5 minutes. Do not turn off the power.
38
Advertisement
Table of Contents
