Setting The On File Character; Setting The Not On File Character - Metrologic IS1000 Series Configuration Manual

4.3.1. Setting the On File Character

This function can be used to change the On File Character sends by the host.
By default: Character ~ (7E hexa).

4.3.2. Setting the Not On File Character

This function can be used to change the Not On File Character sends by the host.
By default: Character DEL (7F hexa).
START OF CONFIGURATION
IS1000 – Configuration Guide
ACCESS CODE
ON FILE CHARACTER
Enter the desired character
using the Code 39 Full ASCII Table page 70
VALIDATION
ACCESS CODE
NOT ON FILE CHARACTER
Enter the desired character
using the Code 39 Full ASCII Table page 70
VALIDATION
49
END OF CONFIGURATION