Fixed Length(S) Authorized And Set Using The Numeric Pad - Metrologic IS1000 Series Configuration Manual

3.3.2. Fixed Length(s) Authorized and Set Using the Numeric Pad

Select the number of code length(s) desired (1 to 4):
THREE
Select the N° of the length to be adjusted:
LENGTH N° 1
LENGTH N° 3
Go back to adjust a next N° of length or read the code End of Configuration if no
other lengths is desired.
!
Note:
In this mode, the code lengths are saved after power-off.
START OF CONFIGURATION
IS1000 – Configuration Guide
ONE
Enter the desired number of characters
using the Numeric Pad page 81
VALIDATION
LENGTH N° 2
LENGTH N° 4
29
TWO
FOUR
END OF CONFIGURATION