JVC KD-SH707 Service Manual page 6

KD-SH707
QQ
3 7 63 1515 0
Removing the CD mechanism assembly
Prior to performing the following procedure, remove
the top chassis.
1. Remove the three screws H inside the top chassis
and remove the CD mechanism assembly.
Removing the motor assembly
Prior to performing the following procedure, remove
the top chassis.
1. Disconnect the wire from connector CN703 on the
main board.
2. Remove the motor bracket and the spring attached
to the arm braket assembly (R).
3. Remove the two screws I
bracket.
TE
L 13942296513
4. Remove the washer attaching the clutch assembly
and pull out the clutch assembly from the shaft.
5. Remove the two screws J and the motor assembly
from the motor bracket.
Motor braket
Clutch assembly
www
Washer
Fig.11
1-6
http://www.xiaoyu163.com
(See Fig.8)
(See Fig.9 to 11)
attaching the motor
Motor assembly
J
x ao
y
. i
http://www.xiaoyu163.com
8
Top chassis
H
Spring
Q Q
3 6 7 1 3
Arm braket assembly (R)
Main board
u163
.
2 9 9 4 2 8
H
CD mechanism assembly
Fig.8
Motor braket
1 5 0 5 8 2 9 9 4
Motor assembly
Fig.9
CN703
I
Motor bracket
I
m
co
Fig.10
9 9
H
2 8 9 9