JVC KD-SH707 Service Manual page 11

QQ
3 7 63 1515 0
<Front panel assembly>
Prior to performing the following procedure, remove
the front panel assembly.
Removing the front board
1. Remove the four screws V attaching the rear panel
to the front panel assembly.
2. Release the eleven joints g of the front panel and the
rear panel.
3. Disconnect the wire from connector CN803 on the
front board.
4. If necessary, unsolder the front board.
Removing the volume board
Prior to performing the following procedure, remove
the rear panel.
TE 1. Remove the four screws W attaching the volume
L 13942296513
board.
2. Disconnect the volume knob, ring lens and volume
ring from the volume board.
3. If necessary, unsolder the volume board.
Removing the line in board
Prior to performing the following procedure, remove
the rear panel.
1. Disconnect the wire from connector CN803 on the
front board.
2. Pull out the line in board from the front panel
assembly.
www
.
http://www.xiaoyu163.com
(See Fig.25 and 26)
(See Fig.26 and 27)
(See Fig.26 and 28)
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
V
V
Joint g
Front board
W
Line in board
Q Q
3 6 7 1 3 1 5
Ring knob
Line in board
co
.
9 4 2 8
Rear panel V
V
11
Fig.25
Soldering
W
Soldering
Volume board
W
W
CN803
Fig.26
0 5 8 2 9 9 4 2 8
Volume board
Volume lens, Volume ring
Fig.27
m
Fig.28
KD-SH707
9 9
9 9
1-11