TransAct EPIC 950 Troubleshooting Manual page 9

Racking/Unracking the Inner Chassis
To remove the Inner Chassis
 Pull on the Ticket Cover to release the rear detents, pulling the Inner Chassis towards you until its latches
catch the forward detent slots.

Push the Inner Chassis back in slightly, pull on the Release Lever and pull forward on the Inner Chassis to
undock it from the Outer Chassis.
To return the Inner Chassis: (see warning before racking)
 Align the base of the Inner Chassis with the outer walls of the Outer Chassis, seating it within side walls A
and B as shown. Make certain it's straight so the inner chassis doesn't damage the flex cable.
 While pulling outwards on the Release Lever, slide the Inner Chassis towards the rear of the Outer Chassis.
Push the Inner Chassis all the way to the back until it stops. When fully seated, the front metal plate of the
inner chassis and the front left edge of the outer chassis are flush.
 WARNING: Interconnect PC Board Assembly must be latched in position shown.
 Push the Inner Chassis back in slightly, pull on the Release Lever and pull forward on the Inner Chassis to
undock it from the Outer Chassis.
Check by trying to move the board by hand prior to racking.
MAKE SURE IT IS LATCHED