GE C2S985 Technical Service Manual page 32

4. Remove the four T-15 Torx screws (2 not shown)
holding the front of the cooktop to the control
panel.
5. Remove the three 1/4-in. hex-head screws and
the vent trim.
6. Remove the two 1/4-in. hex-head screws from
the rear of the cooktop and remove the cooktop
from the range.
To remove the cooktop (Profi le and GE models):
1. Remove the surface burner igniters and the
screws holding the burners to the cooktop. (See
To remove the cooktop (Café models)
2. Insert a putty knife between the cooktop and
manifold panel 2 inches from either side.
3. Lift the cover as you push in each release clip.
Note: The cooktop panel hinge slots rest on a hinge
pin mounted to each end plate.
4. Lift the front of the cooktop panel upward
Vent Trim
5. Lower the rear of the cooktop panel to
6. Lift the cooktop panel up and over the hinge
, steps 1–3.)
Note: Range shown with control panel removed for
clarity.
– 32 –
approximately 45 degrees.
disengage the hinge slots from the hinge pins.
pins and remove the cooktop panel.
Hinge Pin
Hinge Slot