Advertisement
Aeronautical Products
CDS Installation
OEM Version
NOTE:
after installing the CDS make sure that all on-board instruments and systems perform
as expected. Verify the on-board compass calibration.
EKP V Docking Station
Standard Version
1.
Cut the cockpit using the cutting template
provided in the box.
2.
Connect and secure the included DB-15
interface (direct soldering or clamp board,
depending on the CDS version) on the
back of the CDS.
3.
Connect
required
connection, as explained in the previous
chapter.
4.
Connect USB cables and secure them
with the included safety lock bar.
5.
Install the docking station in the cockpit
hole and secure it with the flush mount
braked. Push the bracket in the center and
flex it until it is possible to lock it with the
provided nuts.
6.
Fasten and secure the wires to the back of
the CDS, to avoid vibrations or mechanical
stress on the connections.
Installation Guide -
wires
to
DB-15
9
Advertisement
