Table of Contents
Advertisement
31/4' ' x 10" (8.3 cm x 25.4 cm) Vent System
Vent Piece
31/4 " x 10" (8.3 cm x 25.4 cm)
5.0 ft
90 ° elbow
(1.5 m)
31/4 " x 10" (8.3 cm x 25.4 cm)
12.0 ft
flat elbow
(3.7 m)
31/4" x 10" (8.3 cm x 25.4 cm)
0.0 ft
wall cap
(0.0 m)
Example Vent System
31/4"
x 10"
(8.3
x 25.4
cm)
elbow
6 ft (1.8 m)
1 - 90 ° elbow
= 5.0 ft (1.5 m)
8 ft (2.4 m) straight
= 8.0 ft (2.4 m)
Length of 31/4" x 10"
= 13.0 ft (3.9 m)
(8.3 cm x 25.4 cm) system
PREPARE THE LOCATION
Before making
cutouts, make sure there is
proper clearance
within the ceiling or wall.
1. Disconnect power.
2.Select a fiat surface for assembling the range hood.
Place covering over that surface.
3.Lift the range hood and set it upside down onto covered
surface.
4.If cabinet has recessed bottom, add wood filler strips
on each side. Install screws to attach filler strips in
locations shown.
Wood filler strips
(recessed cabinet
bottoms only)
ii___ionlt
__
_
50 UXn_ 3 n gmsCmreW
s
\
\ \
\
\
\ \
\
\
\ \
\
\
\ \
\
\
\ \
\
\
.1
Wall
3" (7.6 cm)
Determine
Wiring Hole Location
1.Determine and clearly mark a vertical centerline on
the wall and cabinet bottom.
A Centerline
li ,/
ii Iii,,'_li,j_'l
, _11
k
Advertisement
Table of Contents
