Prepare Hood - Frigidaire HC88 Series Installation Instructions Manual

FIG. 2
STEP 2
STEP 3
STEP 4

PREPARE HOOD

1. Unpack hood and check contents. You should receive:
Discard damper/duct connector and two black sheet metal
screws.
For Steps 2 - 6 below, refer to FIG. 2.
2. Set hood upside down and remove bottom cover and
3. Remove filters.
4. Remove wiring box cover and screws.
5. To make hood lighter and easier to handle, remove blower
STEP 6
DO NOT GRASP BLOWER BY BLOWER WHEELS.
STEP 5
WHEELS MAY BE DAMAGED.
6. Remove light lens. Squeeze sides of lens toward center of
7. Remove either top or rear electrical knockout. (FIG. 3)
7. Remove either top or rear duct knockout. (FIG. 3)
FIG. 3
3
1 - assembled hood
1 - plastic bag, containing:
4 - 7/8" wood screws for mounting hood to cabinet
2 - 1/4" black sheet metal screws for mounting damper/
duct connector to hood
2 - aluminum filters
1 - damper/duct connector
For Ductfree Installations Only:
screws.
assembly.
a.) Unplug blower.
b.) Loosen knurled nuts on mounting rods and slip rods
out of blower mounting brackets. Do not remove nuts
completely from rods.
c.) Lift out blower and set blower aside.
CAUTION
hood and lift lens out.
For Ducted Installations Only:
Fasten damper/duct connector to hood over opening.
Use two black sheet metal screws provided in parts bag.
(FIG. 3)
ELECTRICAL
KNOCKOUTS
HORIZONTAL DUCTING*
* FOR DUCTED INSTALLATIONS ONLY.
VERTICAL DUCTING*
HINGE
PINS
DUCT
KNOCKOUTS*
HINGE
PINS