LOTOS LTPDC2000D User Manual page 5

b) If you want to dynamically control the welding heat, please use a foot pedal (not included in the
box. To purchase, please go to our website). Then connect the "on/off" connector to your foot
pedal and leave the wire of the TIG torch unplugged.
- Set TIG Weld/Stick Weld/Plasma CUT to TIG Weld mode (refer to Figure 1.4, page 2).
- Set "2.5S/5S" to "2.5S" mode.
- Set "Machine/PEDAL" to "Pedal" mode.
- Adjust current dial between 10 and 200 amps (Figure 1.9).
Tig Torch
Output
3. TIG torch head parts (Figure 1.9) and assembly (Figure 1.10)
(The tungsten is not included in the picture; please buy proper DC Lotos tungsten electrodes.)
Grind and sharpen the tungsten before first use.
(Leave the torch switch unplugged.)
Figure 1.10
Foot
Pedal
with
Amp Adjusts
5-pin
Figure 1.9
Foot Pedal
Plug
Figure 1.9
Figure 1.11
Gound
Cable
4