LOTOS LTPDC2000D User Manual page 4

Output
from
Air
Compressor
Argon
Gas
Machine
Air
Compressor
- Connect your TIG torch and ground cable to the front panel of the machine.
- Make sure the ground cable is connected on the right hand side where the "+" sign is located
- Set TIG Weld/Stick Weld/Plasma Cut to TIG Weld mode (refer to Figure 1.4, page 2)
- Set "2.5S/5S" to "2.5S" mode.
- Set "Machine/PEDAL" to "Machine" mode.
- Adjust current dial from 10 to 200 amps (Figure 1.8).
TIG
Torch
Output
Gas
Inlet
Figure 1.5
a) If you switch from plasma cutting to TIG welding quite often,
consider buying a LOTOS 3 way valve kit to connect both the
argon tank (Figure 1.7) and the air compressor simultaneously.
Figure 1.7
15-20
min/L
Argon
Regulator
Figure 1.8
Figure 1.6
5-pin
Switch
Plug
3