Jaga COCOON Installation Instructions

INSTALLATION INSTRUCTIONS
COCOON
FITTING PACK
Contents:-
Chrome
blank plug
Air Vent
Screws
Washers
Always retain label
Rawl Plugs
with element until installation
is complete. This will assist in
(Kit is located within shrink
casing pack selection (see fig. 6)
wrap of element)
RIGHT HAND CONNECTIONS
H = 20.5cm (205mm)
from finished floor
Cut away ends of shrink wrap, remove fitting
Fig. 1
kit and push fit brackets onto end element plate.
Illustration shows brackets fitted for right hand
connections.
Drill 8mm holes, fit Rawl plugs
Fig. 4
and screw unit to wall.
HEATING ELEMENT
POSITIONING DETAILS
Alternatively,
if you need
left hand
connections –
turn bracket
through 180°
before clicking
onto heat
exchanger
Fig. 5
When fixing and pipe work complete. Assemble casings as overleaf
FIXING BRACKETS
Number of brackets
required for casing
lengths:-
40cm to 120cm = 2
140cm to 220cm = 3
240cm to 300cm = 4
LEFT HAND CONNECTIONS
Fit central
Fig. 2
support feet
if unit is
140cm long
or above, see
instructions
packed with
feet.
Fit valves and connect pipe Fig. 6
work. Units can now be filled
and tested, but do not fit TRV
head at this point.
If top valves are being used Each front panel is 10cm high.
refer to instructions packed
with valve kits. 4 bracket nibs = 40cm plus
20cm to floor = casing height
required
Element Label
Casing pack
required
CENTRAL SUPPORT
FEET
Number required for
casing lengths:-
40cm to 120cm = 0
140cm to 220cm = 1
240cm to 300cm = 2
H = 20.5cm (205mm)
from finished floor
Offer up unit and mark wall fixings,
Fig. 3
positioning underside of heat exchanger
205mm above finished floor level
205mm
Example. Casing pack selection.
60cm (600mm)
L50, Type 10
60. 50. 10.
H L D
JAGAUK cocoon 03.03