Checking The Printing Alignment; Packing And Shipping The Machine - Brother DCP-130C User Manual

Checking the printing
alignment
a
Press Ink Management.
b
Press a or b to choose Test Print.
Press OK.
c
Press a or b to choose Alignment.
Press OK.
d
Press Mono Start or Colour Start.
The machine starts printing the
Alignment Check Sheet.
Is Alignment OK?
aYes bNo
e
Check the 600 dpi and 1200 dpi test
prints to see if number 5 most closely
matches number 0.
If the number 5 sample of both the
600 dpi and 1200 dpi are the best
matches, press a (Yes) to finish
Alignment Check, and go to step h.
If another test print number is a
better match for either 600 dpi or
1200 dpi, press b (No) to choose it.
f
For 600 dpi, press a or b to select the
number of the test print that most closely
matches the number 0 sample (1-8).
600dpi Adjust
Select Best #5
Press OK.
g
For 1200 dpi, press a or b to select the
number of the test print that most closely
matches the number 0 sample (1-8).
1200dpi Adjust
Select Best #5
Press OK.
h
Press Stop/Exit.
Troubleshooting and Routine Maintenance
Packing and shipping
the machine
B
CAUTION
It is important to allow the machine to 'park'
the print head after a print job. Listen
carefully to the machine before unplugging
it to make sure that all mechanical noise
has stopped. Not allowing the machine to
finish this parking process may lead to print
problems and possible damage to the print
head.
a
Open the ink cartridge cover.
b
Pull the lock release levers down and
take out all the ink cartridges. (See
Replacing the ink cartridges on page
32.)
c
B
35