If the legs are not used and the cooker is mounted onto a plinth, fit transit legs to allow for
clearance.
Once the legs are adjusted to a nominal cooker height of 910 mm, fit the anti-tilt restraint
bracket.
1. Fit the flat strap to the rear at the centre point on the lower edge using the supplied screw.
2. Mark the centre position of the cooker installation position on the floor.
3. Measure from the rear most point of the hob to the mount point of strap. (Dimension A),
then using Dimension A mark the back edge of the bracket on the centre line. Use the
bracket to mark the fixing point.