Table of Contents
Advertisement
Electrical supply
The cooker requires connection to a 10 Amp wall socket.
Instructions
1. The model number and the type of appliance, gas pressure and gas type are found on
the inside of the oven door, centre bottom.
2. The appliance requires connection to a 240 V,50 Hz electric supply. The power point
must be installed by an authorized person.
3. Before commencing any work, make sure that the power point switches are turned off
and the three pin plug is removed.
4. If the appliance cannot be adjusted to perform correctly contact your local gas utility.
5. Instruct the user in the operation of the appliance before leaving.
Vertical clearances:
The cooker should be installed so that a vertical clearance of at least 600 mm is maintained
between its burners and any combustible material, and where this is not practical, the
underside of any combustible material less than 600 mm above the burner should be
protected by noncombustible millboard at least 6 mm thick which is covered with sheet
metal not less than 0.4 mm thick, or should be protected by an equivalent material,
extending at least 225 mm beyond the sides of the cooker.
Overhead clearances:
Range hoods and exhaust fans should be installed in accordance with the manufacturer's
instructions. However, in no case should the clearance between the top of the highest burner
of the cooking appliance and the underside of a range hood be less
overhead exhaust fan,
Side clearances
If the distance measured from the periphery of the nearest burner to any vertical
combustible surface, is less than 200 mm, the surface should be protected in accordance
with clause 5.12.1.1 and 5.12.1.2 of A5 5601.
Installation
Make sure the minimum clearances to combustible materials are maintained during the
installation including adequate space for the operation and servicing of the cooker. For
height limitations use the dimensions as shown in the drawing.
Overall dimensions (with legs adjusted to 180mm).
750 mm.
to vertical surface:
than 600mm,
or an
Advertisement
Table of Contents
