Table of Contents
Advertisement
must be installed. Refer to the instructions for installation.
Before connecting your new cooker
Before using your new cooker, please read these 'Instructions for Use' carefully. They
contain important information concerning your personal safety as well as on use and care
of the oven.
Please keep the operating and installation instructions in a safe place; this important
documentation may also be of use to a possible subsequent owner.
Do not use the cooker if it is damaged in any way.
Installation and connection of the cooker should be performed according to the
instructions and connection diagram provided, and should be entrusted to a licensed
specialist. In the event of damage that occurs as a result of improper connection, the
warranty will be void.
Our appliances meet the applicable safety regulations for electrical appliances. Repairs
may be performed only by authorised persons. Inexpert repairs may cause serious injury to
you, the user.
Safety considerations
Never leave the appliance unattended when cooking with fat or oil. It could ignite if
overheated.
In case of a defect, switch off at the mains.
Do not clean the oven with steam or high pressure cleaners.
Ensure that the power cord does not get caught in the hot oven door. The plastic
insulation could melt.
Do not use loose greaseproof paper in the oven (e.g. when heating the oven). The paper
could be drawn to the fan and damage the fan and the element.
Do not insert a baking sheet or aluminium foil sheet at the bottom of the oven. A heat
build-up could result and cooking times and temperatures could change or enamel could
be damaged.
Do not pour water on the hot oven floor. Damage to enamel could result.
Always place a baking tray below a roast to prevent juices from dripping on the oven lining.
Do not place heavy items on the oven door when open as this may result in damage to the
door hinges.
To ensure correct cooking the oven door must be closed properly.
Keep the door sealing surfaces clean at all times.
Installation instructions
Statutory regulations
This appliance should
be installed in
with the manufacturer's installation
accordance
instructions, local gas fitting regulations, municipal building codes, electrical wiring
AS 5601
regulations,
the Australian Standard for gas installations. Refer also to AS 5601
for pipe sizing tables.
Gas supply
Check that the data plate shows the appliance is suitable for the available gas supply. The
data plate is located on the inside of the oven door, centre bottom.
Advertisement
Table of Contents
