SCAN domestic SFO 2201 User Manual page 29

Problem
Technical Dishwasher will not
problems start
The water is not
pumped out
General prob- Suds in the tub
lems
Stained tub interior
White film on inside
sufface
Rust on the cutlery
Noise Knocking noise
Rattling noise
Knocking noise in
the water pipes
Unsatisfied The dishes are not
washing clean
result
Possible causes What to do
Fuse blown, or the circuit Replace fuse or reset circuit breaker.
breaker tripped.
Remove any other appliances sharing the same circuit with
the dishwasher
Power supply is not turned Make sure the dishwasher is turned on and the door is closed
on. securely.
Make sure the power cord is properly plugged into the wall
socket.
Door of dishwasher not prop- Make sure to close the door property and latch it.
erly closed.
Kink in drain hose Clean The Filter
Filter clogged. Check kitchen sink to make sure it is draining well.
Kitchen sink clogged. If the problem is the kitchen sink not draining ,you may need a
plumber rather than a serviceman for dishwasher.
Improper detergent Use only the special dishwasher detergent to avoid suds. If this
occurred, open the dishwasher and let suds evaporate. Add 1
gallon of cold water to the tub. Close and latch the dishwasher,
then Start any wash cycle to drain out the water. Repeat if
necessary.
Spilled rinse-aid Always wipe up rinse-aid spills immediately.
Detergent with colourant was Make sure that the detergent is the one without colourant
used
Hard water minerals To clean the interior, use a damp sponge with dishwasher de-
tergent and wear rubber gloves.
Never use any other cleaner than dishwasher detergent for
the risk of foaming or suds.
The affected items are not
corrosion resistant.
A programme was not run Always run the Quick wash programme without any crockery
after dishwasher salt was in the dishwasher and without selecting the Turbo function (if
added. Traces of salt have got present), after adding dishwasher salt.
into the wash cycle.
The lid of softer is loose. Check the lid. Ensure the fix is fine.
The spray arm is knocking Interrupt the program, and rearrange the items which are ob-
against an item in a basket. structing the spray arm.
Item of crockery are loose in Interrupt the program, and rearrange the items of crockery.
the wash cabinet
This may be caused by on- This has no influence on dishwasher function. If in doubt, con-
site installation or the cross- tact a suitably qualified plumber.
section of the piping.
The dishes are not loaded See notes in " Loading the Dishwasher Baskets ".
correctly
The programme was not Select a more intensive programme.
powerful enough.
See" Wash Cycle Table ".
Not enough detergent was Use more detergent, or change your detergent.
dispensed.
Item are blocking the path of Rearrange the items so that the spray can rotate freely.
spray arms.
The filter combination in the Clean and/or fit the filter combination correctly.
base of wash cabinet is not
Clean the spray arm jets. See "Cleaning the Spray cabinet is
clean or is not correctly fitted.
not clean or Arms".
This may cause the spray arm
jets to get blocked.
29