Maintenance And Cleaning - SCAN domestic SFO 2201 User Manual

Forgot a dish
A forgotten dish can be added any time before the detergent
cup opens.
1 Press the Start/Pause button.
2 Open the door a little to stop the washing.
3 After the spray arms stop working,you can open the door
completely
4 Add forgotten dishes.
5 Close the door.
6 Press the Start/Pause button, the dishwasher will run after
10 seconds.
At the end of the wash cycle
When the working cycle has finished, the buzzer of dishwasher
will sound 8 seconds, then stop.
Turn off the appliance using the ON/OFF button, shut off the wa-
ter supply and open the door of the dishwasher. Wait a few min-
utes before unloading the dishwasher to avoid scald, the dishes
and utensils are still hot and more susceptible to breakage. They
will also dry better.
• Switch Off the Dishwasher
Switch off the dishwasher by pressing the ON/OFF button.
• Turn off the water tap!
• Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should be
allowed to cool down around 15 minutes before removing
from the appliance.
Open the dishwasher's door, leave it ajar and wait a few
minutes before removing the dishes. In this way they will be
cooler and the drying will be improved.
• Unloading the dishwasher
It is normal that the dishwasher is wet inside.
It is dangerous to open the door when washing, because the
hot water may scald you.

Maintenance and cleaning

Filtering system
The filter prevent larger
remnants of food or other
objects from getting inside
the pump.
The filter system consists of
a coarse filter, a flat (Main
filter) and a micro filter
(fine filter).
A - Main filter
Food and soil particles trapped by this filter are pulverized by a
special jet on the spray arm and washed down to drain.
B - Fine filter
This filter holds soil and food residues in the sump area and pre-
vents it from being redeposited on the dishes during a cycle.
C - Coarse filter C
Larger items, such as pieces of bone or glass, that could block the
drain are trapped in the coarse filter. To remove the items caught
by this filter, gently squeeze the tap on the top of thisfilter and
lift it out.
Filter assembly
The filter efficiently removes food particles from the wash water,
allowing it to be recycled during the cycle.
For best performance and results, the filter assembly must be
cleaned regularly.
For this reason, it is a
good idea to remove
the larger food parti-
cles trapping in the fil-
ter after each wash cy-
cle by rinsing the filter
and cup under running
water. To remove the
filter assembly, pull
the cup handle in the
upward direction.
Warning
Never run the dish-
washer without the
filters in place.
The dishwasher must
never be used without
the filters.
Improper replacement
of the filter may re-
duce the performance
level of the appliance and damage dishes and utensils.
Step 1: Contrarotate the filter assembly, then lift it all up.
Step 2: Lift B and C up from A;
Step 3: Separate B and C.
Remark:
If do it from step1 to step 3, the filter system will be removed;
while if do it from Step 3 to Step 1, the filter system will be
installed.
- Inspect the filters for blocking after every time the dish-
washer has been used.
- By unscrewing the coarse filter, you can remove the filter
system.Remove any food remnants and clean the filters
under running water.
Important:
The entire filter assembly should be cleaned once a week.
Cleaning The Filter
To clean the coarse filter and the fine filter, use a cleaning brush.
Reassemble the filter parts as shown in the figures on the last
page and reinsert the entire assembly in the dishwasher, posi-
tioning in its seat and pressing downward.
Warning
When cleaning the filters , don't knock on them. Otherwise, the
filters could be contorted and the performance of dishwasher
could be decreased.
26