Split Temporal Mode of Operation
4.
An End-of-Line Resistor must be installed between terminals 5 & 6 for control module wiring
supervision (the ELR value is dependent on the module employed).
5.
For a list of compatible devices, refer to the HPP Device Compatibility Document #54399.
5.3 Split Temporal Mode of Operation
In this application, the power supply has been set as a master with two synchronized and two non-
synchronized outputs as determined by the Split Temporal mode feature. Control Input #1 (TB4,
Terminals 3 & 4) is connected to an addressable control module which will cause the synchronized
HPF24S Series Power Supplies — P/N 52751:E1 4/14/2011
Applications
31