Honeywell HPF24S6 Installation Manual page 30

Applications
The control module is shown to demonstrate the use of a remotely mounted device associated with
an addressable fire alarm control panel. The module could be replaced with any circuit capable of
polarity reversal, such as an FACP Notification Appliance Circuit.
ELR not required for
Style Z (Class A) NAC
Door Holder
Internal Trouble Contact
HPF24S
SLC
Control Module*
*If the SLC device does not match the one in this
figure, refer to the SLC manual wiring conversion
charts for legacy and newer versions of the modules.
Figure 5.2 Controlling Three NACs and One Door Holder With One Input
The following notes apply to Figure 5.2 on page 30.
1. The Output 4 door holder circuit will deactivate 10 seconds after Control Input #1 is activated
or AC power is lost.
2. When the HPF24S power supply is in an inactive state (control module not active), a trouble
on the power supply will result in an open circuit condition on the control module output
circuit (monitored by an End-of-Line Resistor across Terminals 5 & 6). As an alternative, the
trouble contacts at TB5 of the power supply can also be used for independent trouble
monitoring.
3. Do not loop wires under screw terminals. Break wires to maintain proper supervision.
30
Controlling Three NACs and One Door Holder With One Input
Note: All NACs are supervised and power-limited
Horn/Strobes
Alarm Polarity
Shown
Style Z (Class A)
ZNAC-4
Option Module
End-of-Line Resistor
supplied with Control
Module
Use listed ELR
(4.7K) to
terminate Style Y
(Class B) NAC
Door Holder
Style Y (Class B)
Door Holder Circuit 4
Output/NAC 3
Output/NAC 2
Output/NAC 1
SW1 Switch Settings
1 & 2 = sync (any setting but OFF/OFF)
3 = OFF (master)
4 = OFF (no AC Fail reporting delay)
5 = OFF
(general alarm)
6 = OFF
7 = OFF (charger enabled)
8 = ON (circuit 4 door holder)
HPF24S Series Power Supplies — P/N 52751:E1 4/14/2011
Horn/Strobes
Alarm Polarity
Shown