Assembly - Tunturi GO 10 User Manual

ASSEMBLY

As for the assembly of the device, we
recommend two grown-up persons. Do
not take the treadmill out of the box: use
the packing material to cover the fl oor on
the assembly site.
Before assembling the device, insure all
parts are present:
1. Frame
2. Power cord
3. Assembly kit: keep the assembly
tools, as you may need them e.g. for
adjusting the equipment
In case of problems contact your Tunturi
dealer. The directions left, right, front
and back are defi ned as seen from the
exercising position. To avoid injury, you
must fold up the deck prior to lifting the
treadmill out of the box.
Locate the hardware bag and parts
that are listed in the chart below.
Part # Description
A Main frame and console
B Side cap
C Screw
D Washer
E Washer
F Screw
G Allen key
H Screwdriver
I Safety key
Lift up the upright, then place the screws
(C) and washers (D, E) inside holes at the
bottom of the upright. Tighten them well.
O W N E R ' S M A N U A L • G O R U N 1 0
Attach the side caps (B) with screws (F) at
the bottom of the upright, and tighten
them well.
Q'ty
1
2
6
4
POWER CORD AND GROUNDING
2
INSTRUCTIONS
6
1
Plug the socket end of the power cord into
1
the treadmill at the left front corner. Before
1
connecting the device to a power source,
make sure that local voltage matches that
indicated on the type plate. The treadmill
operates at 110 V or 230 V.
This treadmill must be grounded. If
it should malfunction or breakdown,
G B
3