Operation To Reset; Cd Player Unit; Remote Control Unit - Kenwood CD-406 Instruction Manual

CD player unit
111111111k,
The unit is not turned ON with the ON/
•Power plug is loosely connected.
STANDBY (POWER/1 / (5) switch ON.
•With the power plug connected to the switched
AC outlet of an amplifier, the power of the
amplifier is turned off.
• Insert the power plug firmly to the AC outlet.
• Turn the amplifier's power ON.
• Disc is cracked.
• Condensation has occurred on the optical lens
unit.
• The connection cords are inserted loosely.
• Output level is attenuated too low.
• Insert disc properly.
• Wipe off the dust on the surface of the disc
referring to "Disc handling precautions".—[::]
• Replace the disc with a new one.
• Remove any condensation from the unit by
referring to the section entitled, "Caution on
condensation".
• Connect all connection cords firmly.
• Adjust the output level with OUTPUT key on
the remote control unit.
Sound is not heard with the
key on.
• Disc is loose.
• Disc is too dirty.
Music is interrupted. (Sound is skipped.)
• Disc is too dirty.
• Disc is cracked.
• Oscillation is applied to this unit.
• Wipe off the dust on the disc surface referring
to "Disc handling precautions".
• Replace the disc with a new one.
• Try selecting a place where no strong vibrations
occur by changing the installation place, etc.
Play begins as soon as the unit is turned ON. • This unit is designed so that play begins auto-
matically when the unit is turned ON if a disc is
already loaded.
• If automatic play is not required remove the
disc from the player before setting the unit to
STANDBY mode.
Operation to reset
The microcomputer may malfunction (impossibility to operate,
erroneous display, etc.) when the connection cords are un-
plugged while the unit is ON or due to an external factor. In this
case, execute the following method to reset the microcomputer
and return it to normal condition.
Unplug the power cord from the power socket and plug the
power cord into the socket again.
4100141,10 13,
LI"l
k
,
ANOMMit :afifinienna'
1.10111601blastitik
madattsatititaisaittlik
What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the table
below to see if the problem can be corrected before seeking help from your dealer or service representative.
Remote control unit
Remote control operation is not possible.
• Batteries are exhausted.
• The remote control unit is too far away from the
main system, controlling angle is too large, or
there is an obstacle in between.
• Replace with new batteries. —X
• Operate the remote control unit within the
controllable range.
—X
For the U.S.A.
CAUTION:
Use of controls or adjustment or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
In compliance with Federal Regulations, following are reproductions of
labels on, or inside the product relating to laser product safety.
KENWOOD CORPORATION
2967-3, ISHIKAWA-CHO, HACHIOJI-SHI,
TOKYO, JAPAN
" KENWOOD CORP. CERTIFIES THIS EQUIPMENT
i
CONFORMS TO DHHS REGULATIONS NO. 21
CFR 1040.10, CHAPTER 1, SUBCHAPTER J.
Location: Back Panel
J