Kenwood CD-406 Instruction Manual page 21

To wall AC outlet
Audio timer
ININONIMINWEENDIENINEINENemeiNENNIEssonsingnotemenegionggigeonsenamegentiesommossonsammanotomma „,„„ gpismonnowasompnosmimign
gettleatight:
Timer playback of CD can be started at any time using an
audio timer which is available in audio stores.
in
Turn the powers of the associated components
mi. ON.
Preparation
4
Set the timer ON time.
Fj
Set the amplifier volume.
G
Adjust the amplifier volume.
Set the timer so that it supplies power at the
specified time.
Turn OFF the power output from the audio
timer.
• If the amplifier is not connected to the CD player through a system
control cord, select the "CD" input with the input selector.
• With some audio timer models, the power is automatically turned OFF
when the timer ON time is set. With such a model, skip step 0 below.
• Do not touch the ON/STANDBY (POWER/I /0) keys of the amplifier
and CD player.
• When the set time comes, the disc playback starts automatically.
1. Some amplifiers cannot be used with a timer. Before using a amplifier, check it.
2. When operating the unit other than CD player using an audio timer, be sure to remove the disc from the CD player.
o
po
000
(0000)
This unit
m.
1=11=1=
CI
System control cord Audio cord
Amplifier or receiver
12 : 00
Preparation
•
Connect the power cords of the associated
components so that their power can be
turned ON through the audio timer.
(Also, be sure to read carefully the instruc-
tion manual of the timer.)