Fcc Warning; For Your Records - Kenwood CD-406 Instruction Manual

Wovrat4itkepo..kwa
CD-406/DPF-R6030
CD-404/403/DPF-R4030/3030
[ Format ]
[ Format ]
System
Compact disc digital audio system
System
Compact disc digital audio system
Laser
Semiconductor laser Laser
Semiconductor laser
[ D/A Convertors ]
[ D/A Convertors ]
D/A Conversion
1 Bit (D R.I.V E.)
D/A Conversion
1 Bit
Oversampling
8 fs (352.8 kHz)
Oversampling
8 fs (352.8 kHz)
[ Audio ]
Frequency response
4 Hz - 20 kHz, ±0.5 dB
Signal to noise ratio
More than 105 dB
Dynamic range
More than 95 dB
Total harmonic distortion + noise
Less than 0.005% (at 1 kHz)
[ Audio ]
Frequency response
4 Hz - 20 kHz, ±0.5 dB
Signal to noise ratio
More than 100 dB
Dynamic range
More than 93 dB
Total harmonic distortion + noise
Less than 0.005% (at 1 kHz)
Wow & flutter
Unmeasurable Limit
Wow & flutter
Unmeasurable Limit
Output level/impedance
Output level/impedance
Variable
(Max.) 2 V/1 kfl
Fixed (CD-403/DPF-R3030)
2 V/1 Id2
Digital output
Variable (CD-404/DPF-R4030)
(Max.) 2 V/1 kfl
Coaxial
0.5 V p-p / 75 12
Headphone output (Max.)
Optical
-15 dBm - -21 dBm
(CD-404/DPF-R4030 only)
20 mW (32
Q)
(Wave length 660 nm)
Headphone output
(Max.) 20 mW (32 Q)
[ Laser ]
Wave length
760 nm - 800 nm
[ Laser ]
Laser power class
Class 1 (IEC)
Wave length
760 nm - 800 nm
Laser power class
Class 1 (IEC)
[ General ]
Power consumption
14 W
[ General ]
Dimensions
W : 440 mm (17-5/16")
Power consumption
14 W
H :124.5 mm (4-15/16")
Dimensions
W : 440 mm (17-5/16")
D : 398 mm(15-5/8")
H :124.5 mm (4-15/16")
Weight (Net)
5.1 kg (11.2 Ib)
D :
398 mm(15-5/8")
Weight (Net)
5.1 kg (11.2 Ib)
1. KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
2. The full performance may not be exhibited in an extremely cold location (under a water-freezing temperature).
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the
modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change
or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to
radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- - Reorient or relocate the receiving antenna.
- - Increase the separation between the equipment and receiver.
- - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- - Consult the dealer or an experienced radio / TV technician for help.
KENWOOD
For your records
Record the serial number, found on the back of the unit, in the spaces
designated on the warranty card, and in the space provided below. Refer
to the model and serial numbers whenever you call upon your dealer for
information or service on this product.
Model
Serial Number