Before Operation - Kenwood DP-M993 Service Manual

DP-M993/M5590/M6690 `
BEFORE OPERATION
Beware of Condensation
When water vapor comes into contact with the surface of cold
material, water drops are produced.
If condensation occurs, correct operation may not be possible, or
the unit may not function correctly.
This is not a malfunction, however, and the unit should be dried.
(To do this, turn the POWER switch ON and leave the unit as it is
for several hours.)
English Note:
The unit's power supply is secondarily connected. Note following.
The unit is not completely disconnected from the mains as long
as the power cord is connected to a wall outlet.
Be especially careful in the following conditions:
e When the unit is brought from a cold place to a warm place,
and there is a large temperature difference.
ө When a heater starts operating.
e When the unit is brought from an air-conditioned place to a
place of high temperature with high humidity.
€ When there is а large difference between the internal
temperature of the unit and the ambient temperature, or in
conditions where condensation occurs easily.
Dansk Bemærk:
Strømmen til apparatet afbrydes på den sekundære side. Vear
opmærksom på følgende. Denne enhed er ikke fullstendig koblet
fra lysnettet så lenge stikket er tilsluttet stikkontakten.
Svenska Observera: Norwegian Anmerkning: |
Apparatens strömförsörjning kopplas från sekundärt. V.g. ge akt Strømmen til apparatet ег stått-av på sekundærsiden. Vær
på följande. Apparaten fránkopplas inte helt och hållet från oppmerksom på det fglgende. Dette apparatet koples ikke
strömnätet medan apparatens nätsladd ёг ansluten till fullstendig fra nettet så lenge støpselet står i en stikkontakt, selv
växelströmsuttaget. om strømpryteren settes i av-stilling.
Finnish Huom:
Virta yksikköön on kytketty pois sekundaaripuolelta. Huomioi
seuraava. Tämä yksikkö ei ole kokonaan kypketty pois pää
virranjakajasta kun pää katkaisin on liitettynä virtatiiriin.
Warning
For CANADA
DOC REGULATION
"This digital apparatus does not exceed the CLASS B limits for radio noise emissions from digital apparatus as set out in the radio interference
regulations of the Canadian Department of Communications." |
For the U.S.A.
FCC WARNING:
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if
an unauthorized change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause
harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures: А
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.