Before Operation - Kenwood DP-2060 Instruction Manual

Before operation
Disc handling precautions
Handling 7
Hold compact discs so that you do not
touch the playing surface.
Label side
ese <3 Playing side
Do not attach paper or tape to either the
playing side or the label side of compact
discs... ' :
Caution on disc used
Note related to transportation and movement
Before transporting or moving the CD PLAYER, carry out the following operations.
1. Turn the power ON but do not load a disc.
2. Wait afew seconds and verify that the display shown appears.
3. Turn the power OFF.
Beware of condensation
When water vapor comes into contact with the surface of cold material,
water drops are produced.
If condensation occurs, correct operation may not be possible, or the
unit may not function correctly.
This is not a malfunction, however, the unit should be dried. (To do this,
turn the POWER switch ON and leave the unit as itis for several hours.)
6 DP.2060/DP-1060 {En)
Cleaning
If fingerprints or foreign matter become
attached to the disc, lightly wipe the disc
with a soft cotton cloth (or similar) frorn
the center of the disc outwards in a radial
manner.
Storage
When a disc is not to be played for a long
period of time, remove it from the CD
player and store it in its case.
Never play a cracked or warped disc.
During playback, the disc rotates at high speed in the player.
Therefore, to avoid danger, never use a cracked or deformed disc or
a disc repaired with tape or adhesive agent,
4123 4 5
68 7 86 810
7 1148 14 14 45
16147 18 19 20
Be especially careful in the following conditions:
@ When the unitis brought froma ceid place to a warm place, and there
is a large temperature difference.
e@ When a heater starts operating.
@ When the unit is brought from an air-conditioned place to a place of
high temperature with high humidity.
@ \When there is a large difference between the internal temperature
of the unit and the ambient temperature, or in conditions where
condensation occurs aasily.