Nautilus T916 Owner's And Assembly Manual Addendum page 7

Step 2. Attach Side Covers To Front Cover
(Figures 4 and 5)
2-1 Align the holes in the left side of the
front cover with the brackets attached to
the LH side cover and secure using (2)
screws with plastic caps;
2-2 Align the holes in the right side of the
front cover with the brackets attached to
the RH side cover and secure using (2)
screws with plastic caps.
Note: do not tighten any screws at this time.
Step 3. Install Cover Assembly To Frame
(Figure 6)
3-1 Route the power cord through the
center opening of the front cover;
Note: the rear power receptacle is no longer
available on Treadmills produced after
January 2011.
3-2 Spread the side covers slightly and slide
the entire cover assembly onto the frame;
3-3 Secure the front cover to the frame
using (1) 10-32 x 3/4 screw in the center
hole only;
Note: do not install screws in the two outer
holes of the front cover. Installing these
screws will prohibit the covers from aligning
properly.
3-4 Secure the LH side cover along the
outside of the frame using (3) 10-32 x
3/4 screws;
3-5 Secure the RH side cover along the
outside of the frame using (3) 10-32 x
3/4 screws.
Note: do not tighten any screws at this time.
assembly questions? call 800-235-2233 for help. 7
Figure 4
Figure 5
Figure 6