Table of Contents
Advertisement
be received from the line, microphone, or handset. The #VLS command should
have been previously issued to select the input source.
Parameters:
Result Codes:
begin.
device.
AT#VSD
Enable Silence Detection (Voice Receive)
This command is used to enable or disable Voice Receive Mode
silence deletion.
Parameters:
Result Code:
Command options:
#VSD?
ASCII decimal value in result code format.
#VSD=? Returns the message ,"1".
#VSD=0 Turns off the silence deletion.
#VSD=1 Turns on the silence deletion if the silence sensitivity
setting #VSS is nonzero.
controlled by #VSS.
AT#VSK
Buffer Skid Setting
This command queries and sets the number of bytes
None
CONNECT When voice transfer from modem to DTE can
ERROR
If #VLS=0 and not connected to any input
n=0 or 1; Default: 0 or 1
Returns the current setting of the #VSD command as an
The aggressiveness of the silence deletion is
OK
If n=1
ERROR
Otherwise
Advertisement
Table of Contents
