Table of Contents
Advertisement
AT&D1
setting as follows:
modem as if the asynchronous escape sequence had been entered. The modem
returns to asynchronous command state without disconnecting.
AT&D2
setting as follows:
perform a soft reset as if the Z command were received. The &Y setting
determines which profile is loaded.
up.Auto-answer is inhibited.
AT&Fn
Restore Factory Configuration (Profile)
The modem loads the factory default configuration (profile).The
factory defaults are identified for each command and in the S-Register
descriptions. A configuration profile consists of a subset of S-Registers.
AT&F0
AT&F1
AT&Gn
Select Guard Tone
The modem generates the guard tone selected by this command
according
to the parameter supplied (DPSK modulation modes only). The
parameter value, if valid,
is written to S23 bits 6 and 7.
AT&G0
AT&G1
AT&G2
AT&Kn
Flow control
This command defines the DTE/DCE (terminal/model)flow control
mechanism.
The parameter value, if valid, is written to S39 bits 0,1,and 2.
AT&K0 Disables flow control.
AT&K3 Enables RTS/CTS flow control.(Default for data modem
modes.)
AT&K4 Enables XON/XOFF flow control.
AT&K5 Enables transparent XON/XOFF flow control.
AT&K6 Enables both RTS/CTS and XON/XOFF flow control.
(Default for fax modem modes.)
DTR drop is interpreted according to the current & Qn
&Q0,&Q1,&Q4,&Q5,&Q6 DTR drop is interpreted by the
&Q2,&Q3
DTR drop causes the modem to hang up.
DTR drop is interpreted according to the current & Qn
&Q0,&Q1,&Q4,&Q5,&Q6 DTR drop causes the modem to
&Q2,&Q3
DTR drop causes the modem to hang
Restore factory configuration 0.
Restore factory configuration 1.
Disables guard tone. (Default)
Disables guard tone.
Selects 1800 Hz guard tone.
Auto-answer is inhibited.
Advertisement
Table of Contents
