AOpen FM56-ITU/2 Manual page 39

is written to S31 bits 2 and 3. Note that the Wn command can be
overridden by register
S95 bits(see S95 description).
ATW0 Upon connection, the modem reports only the DTE
speed(e.g.,CONNECT 57600).
ATW1 Upon connection, the modem reports the line speed, the error
correction protocol, and the DTE speed, respectively. Subsequent responses are
disabled.
ATW2 Upon connection, the modem reports the DCE
speed(e.g.,CONNECT 28800). Subsequent responses are disabled.
ATXn Extended Result Codes
This command selects which subset of the result messages will be
used by the modem to inform the DTE of the results of commands.
Blind dialing is enabled or disabled by country parameters. If the user
wishes to enforce fail tone detection, a "W" can be placed in the dial string (see D
command). Note that the information below is based upon the default
implementation of the X results table. Table 3-1 indicates the messages which
are enabled for each X value.
If the modem is in facsimile mode(+FCLASS=1 or 2), the only
message sent to indicate a connection is CONNECT without a speed indication.
ATX0
by country requirements; send only OK, CONNECT, RING, NO CARRIER,
ERROR, and NO ANSWER result codes. Blind dialing is enabled/disabled by
country parameters. If busy tone detection is enforced and busy tone is not
detected, NO CARRIER will be reported. If dial tone detection is enforced or
selected and dial tone is not detected, NO CARRIER will be reported instead of
NO DIAL TONE. The vale 000b is written to S22 bits 6, 5, and 4, respectively.
ATX1
by country requirements; send only Ok, CONNECT, RING, NO CARRIER,
ERROR, NO ANSWER, and CONNECT XXXX(XXXX=rate). Blind dialing
enabled/disabled by country parameters. If busy tone detection is enforced and
busy tone is detected, NO CARRIER will be reported instead of BUSY. If dial
tone detection is enforced or selected and dial tone is not detected, NO
CARRIER will be reported instead of NO DIAL TONE. The value 100b is written
to S22 bits 6, 5, and 4, respectively.
ATX2
by country requirements;send only OK,CONNECT,RING,NO CARRIER, ERROR,
NO DIALTONE, NO ANSWER, and CONNECT XXXX. If busy tone detection is
enforced and busy tone is detected, NO CARRIER will be reported instead of
BUSY. If dial tone detection is enforced or selected and dial tone is not detected,
NO DIAL TONE will be reported instead of NO CARRIER. The value 101b is
written to S22 bits 6, 5, and 4, respectively.
Subsequent responses are disabled.(Default)
Disables monitoring of busy tones unless forced otherwise
Disables monitoring of busy tones unless forced otherwise
Disables monitoring of busy tones unless forced otherwise