Table of Contents
Advertisement
4.9 Configuring Internal Modem With
Windows3.1/95/98/2000/NT
Windows 3.1:
1. From the Main group choose Contr ol Panel icon.
2. Double click on Por ts.
3. Double click on the COM port that the modem is using.
4. Click on Advanced button.
5. Set the base I/O address according to the following table:
COM Port Base I/O Address
1
2
3
4
Set the interrupt line to match modem's setting.
6. Click OK to save and Windows will prompt you to restart the PC.
Windows 95:
1. From the My Computer window, click on Contr ol Panel.
2. Go to System, Device Manager. Check the COM ports listed under Por ts.
If the COM port the modem is using is listed, go to step 5. Click Cancel to
close the System Properties window.
3. Click on the Add New Har dwar e to detect the card.
4. Click the Detail button when the Add New Har dwar e Wizard finishes its
detection. A successful hardware installation and detection should add a
Communication Port. Click the Finish button to complete the Add New
Har dwar e.
5. Click the Modems icon to let the modem wizard search for the new
modem. Windows will query the new modem as 'Standard Modem'. Click
Change button and then Have Disk button. Insert the driver diskette and
press Enter.
6. Select the proper model to finish the installation. After completing the
installation, you can check if the fax/modem was properly installed by
using the following procedure:
1. From My Computer , double click Contr ol Panel.
2. Double click Modems.
3. Select Diagnostics tab.
4. Choose the COM port where the newly installed modem device is. Click
on Mor e Info If the Command and Response box displays results from
ATI1 to AT+FCLA..., it indicates that your fax/modem is set up
properly.
03F8
02F8
03E8
02E8
Advertisement
Table of Contents
