Kubota ME5700 Workshop Manual page 376

ME5700, WSM
Disassembling Three Point System Hydraulic Pump
1. Remove the flange (3) and center plate (1).
2. Remove the backup element (4) and seal element (5).
3. Remove the bushings (6) and (9).
4. Remove the drive gear (7) and driven gear (8).
(When reassembling)
When installing the bushing (6) and (9), be sure to reassemble
them to the each original position and direct bushing grooves
to inlet side as shown in the figure.
Install the driven gear (8) in the correct direction as shown in
the figure.
Take care not to damage the seal element (5), backup
element (4) and O-ring.
Take care not to lose or damage the keys (10) joining the two
bushings.
(1) Center Plate
(2) Housing
(3) Flange
(4) Backup Element
(5) Seal Element
(6) Bushing
(7) Drive Gear
8-S30
HYDRAULIC SYSTEM
(8) Driven Gear
(9) Bushing
(10) Key
(a) Inlet
(b) Outlet
(c) Mark Side
0000002898E
KiSC issued 04, 2006 A