Kubota ME5700 Workshop Manual page 231

ME5700, WSM
Propeller Shaft
1. Slide the propeller shaft cover (1), (6) after removing the
screws (5).
2. Tap out the spring pin (4), (7) and then slide the coupling (3),
(8) to the front and rear.
(When reassembling)
Apply grease to the splines of the propeller shaft (2).
(1) Propeller Shaft Cover
(2) Propeller Shaft
(3) Coupling
(4) Spring Pin
ROPS, Seat and Center Frame
1. Remove the seat (3).
2. Remove the draft and position control lever grips (9).
3. Remove the auxiliary speed change control lever plate (5).
4. Remove the DT shift lever grip (4) and 3-point hitch lowering
speed control grip (6).
5. Remove the plate (7).
6. Remove the auxiliary control valve lever assembly (8).
7. Remove the ROPS (1).
8. Remove the PTO clutch lever assembly (10).
9. Remove the center frame (2).
(When reassembling)
ROPS mounting screw
M16 grade 9
ROPS mounting screw
1/4 grade 5
Tightening torque
ROPS mounting screw
3/8 grade 8
ROPS mounting screw
9/16 grade 8
(1) ROPS
(2) Center Frame
(3) Seat
(4) DT Shift Lever Grip
(5) Auxiliary Speed Change
Control Lever Plate
3-S33
TRANSMISSION
(5) Screw
(6) Propeller Shaft Cover
(7) Spring Pin
(8) Coupling
(ROPS)
0000001895E
260 to 304
26.5 to 31.0
192 to 224 ft-lbs
8.1 to 9.5
0.83 to 0.97
5.97 to 7.00 ft-lbs
47.0 to 53.9
4.8 to 5.5
34.7 to 39.8 ft-lbs
149.0 to 179.3
15.2 to 18.3
109.9 to 132.3 ft-lbs
(6) 3-Point Hitch Lowering Speed
Control Grip
(7) Plate
(8) Auxiliary Control Valve Lever
Assembly
(9) Lever Grip
(10) PTO Lever
0000002581E
KiSC issued 04, 2006 A