Kubota ME5700 Workshop Manual page 244

ME5700, WSM
Differential Side Gear
1. Take out the differential side gear (2) and differential side gear
washer (1).
(When reassembling)
Check the thrust and bearing surface of both differential side
gears (2). If they are worn or damaged, bores in the
differential case may also be damaged. Be sure to replace
their parts.
(1) Differential Side Gear Washer
PTO Clutch Valve
1. Disconnect the PTO clutch valve cable.
2. Remove the PTO clutch valve.
(When reassembling)
Apply transmission fluid to O-ring.
Install the pipes to the hole of the PTO clutch valve firmly.
PTO clutch valve
Tightening torque
mounting screw
(1) PTO Clutch
PTO Clutch and Holder
1. Remove the PTO clutch holder mounting screws.
2. Remove the PTO clutch (2) with PTO clutch holder (1).
(When reassembling)
Apply transmission fluid to O-ring.
Take care not to damage the oil pipes (3).
PTO clutch holder
Tightening torque
mounting screw
When reassembling the PTO clutch assembly, direct the
projection part of brake plate (4) as a figure.
After assembling the PTO clutch assembly, be sure to
check the piston operation by air-blowing.
(1) PTO Clutch Holder
(2) PTO Clutch
3-S46
TRANSMISSION
(2) Differential Side Gear
0000002778E
23.5 to 27.5
2.4 to 2.8
17.4 to 20.3 ft-lbs
0000002779E
23.5 to 27.5
2.4 to 2.8
17.4 to 20.3 ft-lbs
(3) Oil Pipe
(4) Brake Plate
0000002780E
KiSC issued 04, 2006 A