Door Hinge Disassembly - Viking FDB451 Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Door Hinge Disassembly

To access door hinge, slide unit out of the
installation. Next remove the outer door panel
(see Outer Door Removal section, Page 15.).
Disconnect tension cable from hinge.
Remove C-Clip securing hinge.
Note: Remove C-Clip slowly (clip has spring
and can dislodge).
©2012 Viking Preferred Service
! WARNING
Remove two screws that hold each hinge to
the inner door. Repair or replace the hinge as
necessary.
Reverse the procedure to reinstall the hinge.
Disassembly
21