Installing Designer/Professional Series Door Panel; Installing Full Overlay Custom Door Front - Viking DFUD042 Installation Instructions Manual

INSTALLING THE DESIGNER SERIES OR PROFESSIONAL SERIES DOOR PANEL
(Purchased separately)
The unit comes with everything needed to make installing the door panel easy.
1. Peel the adhesive backing off the washers and place
them in line with the four holes (F) on the metal inner
door of the dishwasher.
2. Loosen the screws (D) on the outer edge of the
dishwasher.
3. Pull the fan exhaust frame (E) down until the lower
edge aligns withthe lower edge of the cabinets and
tighten the screws (D).
WARNING!! The door panel must not obstruct the
fan exhaust vent.
4. Hook the door panel screws into the keyholes (C) on
the dishwasher door and pull up on the panel.
5. While holding the door panel into position, carefully
open the dishwasher door. Using the stainless steel
screws provided, fasten the door panel into the four
holes (F) on the inner door.
6. Remove the backing from the protective tape and
apply it to the edge of the panel, in front of the
exhaust vent.
7. Raise the exhaust frame (E) to the bottom edge of
the door panel and tighten screws (D) on the side of
the dishwasher.
NOTE: Door shown is the Designer Series door panel.
INSTALLING THE FULL OVERLAY CUSTOM DOOR FRONT
The dishwasher can be installed with a
custom door panel that extends from the
kickplate to the countertop. The unit
comes with everything needed to make
installing the door panel easy. The inner
door is pre-drilled for the custom door's
mounting screws. The custom panel
should be at least 3/4" (1.9 cm) thick.
ITEMS PROVIDED WITH THE UNIT
(2) 3/8" (.95 cm) screws (B)
(4) 1 3/4" (4.4 cm) screws (F)
CUSTOM OVERLAY DIMENSIONS
Width 23 1/2" (59.7 cm)
Height 29 3/4" (75.6 cm)
Thickness 3/4" (1.9 cm)
Weight Up to 22 lbs. (9.9 kg)
23 1/2"
(59.7 cm)
14 13/16"
(37.6 cm)
12
(Locally supplied)
29 3/4"
(75.6 cm)