Advertisement
http://www.monomachines.com/
offages under normal settings. Make sure there is no gappage in between the
side edges of the stock and guides that hold it straight as it feeds into the unit.
Typically, there is nothing that can be done to a friction fed unit that will prevent
this. Adjusting toner, inking or the amount of drying time are all good
suggestions. This issue can be particularly tough on stocks that are printed on
both sides.
Follow the below steps to clear a jam:
1.
Remove the spring loaded bonnet assembly (shown above).
2.
Manually rotate rollers by spinning the center rubber roller, and one of the
rollers next to it together.
3.
If necessary, remove each of the folding tables by disengaging off of
mounting pin and lowering down until it separates.
http://www.monomachines.com/
1501X OPERATIONAL INSTRUCTIONS
SMUDGING
JAMS
For More Info
VI
Click Here --->
Advertisement
