IDTECK Star 100R User Manual page 28

● Problem
The 100R operates suddenly on general mode during setting or registering a user on mode
selection.
● Cause
▶ Over standby time on mode selection
● Solution
▶ If not entering a key or a card within 20 sec. on mode selection, the product operates on
general mode automatically.
[Registering or Deletion]
● Problem
User Card or PIN cannot be registered additionally.
● Cause
▶ An error in using a product or in system settings
▶ Over permissible register person
● Solution
▶ Make sure that installation and operation are normal.
☞ When installing the 100R first or When finishing system initialization
Because system is the status of initialization, register mode selection, master card
(or PIN) and user.
1. 100R Mode Selection: Mode Number + ENT
RF Only
RF + P/W
PIN Only
RF or PIN
2. Enter the master card (or PIN: 4 to 6digit (mode 03 or 05) + ENT).
3. By modes, enter the master card, PIN and password.
4. Enter the master card (or PIN: 4 to 6digit (mode 03 or 05) + ENT).
Caution
☞ When registering a user card additionally while using a product.
Register a user card only because master card is registered.
1. Enter the master card (or PIN: 4 to 6digit (mode 03 or 05) + ENT).
2. By modes, enter "Mode Number + ENT" to add user access cards.
RF Only
RF + P/W
PIN Only
RF or PIN
3. By modes, enter a user card, PIN and password.
4. Enter the master card (or PIN: 4 to 6digit (mode 03 or 05) + ENT).
Caution
● If the problem still persists, contact our customer service center.
#1)
System Initialization: See page 24 of this manual.
#2)
Initial Setting: See page 10 of this manual.
01 + ENT
02 + ENT
03 + ENT
05 + ENT
See "Initial Setting " to register master or user.
#2)
11 + ENT
12 + ENT
13 + ENT
15 + ENT
See "Initial Setting " to register master or user.
#2)
28
.
#1)