Table of Contents
Advertisement
Processor Multiplier
Processor Voltage
Memory Clock
Flexibility Option
Bank Interleaving
Burst Length
CAS Latency (CL)
TRCD
TRAS
TRP
MA Timing
This Manual: http://www.manuallib.com/file/2448158
This item will show when "Multiplier/Voltage Change" is set to [Manual];
otherwise, it will be hidden. You may set the value from [x4] up to [x25] but
no higher than the value of "Processor Maximum Multiplier". For example, if
the value of "Processor Maximum Multiplier" is [x11], the actual value of
multiplier will be [x11] even if you set this item to a value higher than [x11].
However, for system stability, it is not recommended to adjust the value of
this item.
This item will show when "Multiplier/Voltage Change" is set to [Manual];
otherwise, it will be hidden. You may set the value from [1.550V] down to
[0.800V]. However, for safety and system stability, it is not recommended
to adjust the value of this item.
This item can be set by the code using [Auto]. You can set one of the
standard values as listed: [133 MHz (DDR266)], [166 MHz (DDR333)],
[200 MHz (DDR400)].
The default value of this option is [Disabled]. It will allow better tolerance for
memory compatibility when it is set to [Enabled].
Interleaving allows memory accesses to be spread out over banks on the
same node, or accross nodes, decreasing access contention.
Burst length can be set to 8 or 4 beats. 64 Bit Dq must use the 4 beats.
Use this item to adjust the means of memory accessing. Configuration
options: [Auto], [2.0], [3.0], and [2.5].
Use this to adjust TRCD values. Configuration options: [Auto], [2CLK], [3CLK],
[4CLK], [5CLK], and [6CLK].
Use this to adjust TRAS values. Configuration options: [Auto], [5CLK], [6CLK],
[7CLK], [8CLK], [9CLK], [10CLK], [11CLK], and [12CLK].
Use this to adjust TRP values. Configuration options: [Auto], [2CLK], [3CLK],
[4CLK], [5CLK], and [6CLK].
Use this to adjust values for MA timing. Configuration options: [2T], [1T]. The
default value is [2T].
2 6
Advertisement
Table of Contents
