Metabo BKH 400 Operation Instructions Manual page 23

- IMPORTANT - WIRING INSTRUCTIONS
For machines with a single phase motor (240 volt or 110
volt) the mains lead is to be connected in accordance
with the following colour code:
Green and Yellow
Brown
3-Phase Motors (415 Volts)
Machines fitted with 3-phase motors are connected to the mains using a 5-pin industrial appliance-inlet/connector to
BS 4343 (IEC 309).
Ensure it is wired and connected only by a qualified electrician.
IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN!
SPINDLE MOULDER OPERATOR SAFETY
GENERAL SAFETY
Do not use this machine until you have read:
A: "The woodworking machines regulations 1974
(Factories act 1961 SI 1974 No. 903)
Published by H.M.S.O.
B: The operating instructions is spupplied with this
machine. This document is prepared for worlwide
distribution but certain operations described are
prohibited in the U.K. under 1974 woodworking
machines regulations without further guarding being
added, I.E. grooving, rabbeting, tenoning or
moulding.
Machine No.
PK 250
HS 315
BS 400
BKH 400
KGS 300
KGT 500
UK 330
RECORD POWER-metabo WOODWORKING MACHINERY
IMPORTANT!
We strongly recommend the
use of a Dust Collector
on this machine.
Warning: This appliance must be earthed!
- Earth
Blue - Neutral
- Live
Standard Blade dia. mm
Record Power LTD, Parkway Works, Sheffield
(07 42) 75 63 85/43 43 70
If your machine is supplied with a continental 2-pin +
earth safety appliance inlet, the connector is to be wired
up as follows:
SPECIFIC SAFETY
1. Ensure you follow the safety rules shouwn in the
operation manual.
2. Ensure you know how to switch off the machine in
an emergency.
3. Always wear eye protection.
4. Do not use a crrcular sawblade smaller then 6/10 of
the maximum diameterblade which can be properly
fitted (see table below).
5. Ensure the riving knive is correctly atjusted. When
replacing the blade, enjure the blade plate is thinner
than the riving knive.
6. Always use a push stick in accordance with the
woodworking machine regulations 1974.
7. Ensure guards are always in position and correctly
atjusted (see 1974 regulations for guidance).
250
315
400
400
250
250
250
If your electricity supply conditions present
start-up difficulties we recommend the use
of a BS 3434 type plug and socket.
This work should be done only by a
Earth - Centre pin
}
Live One each to
Neutral other 2 pins
Smallest Blade dia. mm
150
189
240
240
250
250
250
IMPORTANT
qualified electrician.